Wiper parking area defrosters – New high density defrosters

Put the heat low along the bottom of the front windshield

Clear View II Front Wiper Parking Area defrosters melt snow and ice low along the bottom of the front windshield to limit build up and stop wiper freezing even in the toughest weather. Available in 12 and 24 volt.

Front windshield defrsoters for the wiper parking area

Put the heat low on the front windshield

Clear View Front Wiper Area Defrosters safely defrost the area at the bottom of the front windshield in the wiper parking area.

Developed and tested in Colorado’s tough winter conditions these new defrosters work with the vehicles existing hot air defroster to stop wiper freezing, improve wiper operation and enhance the view of the road ahead.

Now with high density (HD) heating element spacing for better defrosting. Available for single and two piece windshields.

Available in several models, Clear View Front Wiper Defrosters fit vehicles from passenger cars all the way up to the largest plow truck.

Front windshiled defrosters

Download the wiper parking product information at the link above.

Keep the wipers moving

Save wiper arms and wiper transmissions plus eliminate stopping to clear the wiper rest area. Enhanced wiper area heating complements the existing hot air defroster effectively eliminating wiper freezing and reducing snow build-up even in the most challenging winter conditions.

Front Wiper Parking Area Defrosters are now available for full and split glass windshields. Edge defrosting in the wiper push area are also now available.

Defrost low on the front window

The vehicles hot air defroster clears the area directly in the drivers line of sight about mid way up the windshield in line with the drivers line of sight.

Clear View Front Wiper Area Defrosters put a measured safe heat low on the front windshield below where normal hot air defrosters warm the glass.

How they work

The defroster elements are sandwiched between two pieces of release paper that when separated allow perfect alignment on the glass. Defrosting is accomplished through contact between the Clear View defroster elements and the window. The defroster is connected electrically through the buss bar tabs and activated with the automatic ThermaSync defroster control and switch.

Front wiper parking area defrosters

Defrost the wiper push area

In tough winter conditions wipers can push snow into areas at the sides of the windshield. This snow build up can limit wiper movement and interfere with visibility. Clear View II Side Defrosters put the heat along the edge of the windshield melting snow and ice in this critical area.

Front windshield defroster elements

Application

The heating elements come on pre-spaced rolls which are trimmed for a custom fit when installed. The self-adhesive heating elements bond directly to the glass and connect to the defrosters side buss bars.

A cover is then applied to the buss bars for a finished factory appearance. The side buss bars include integral tabs are positioned for easy connection to the ThermaSync® defroster control.

Finished Appearance

A cover is applied to the buss bars for a finished factory appearance. Heating elements match the brownish color of factory defrosters and adhere directly to the glass for improved visibility and safe winter driving. No backing is left on the window to fade, crack or yellow over time.

Now in HD

We have reduced the spacing between the heating elements to provide better heat density low on the windshield in the wiper parking area. This better heating performance keeps the wipers moving even in the coldest conditions.

Replacement, Stick Kits

All units have a defroster only replacement option or Stick Kit to accommodate glass damage and windshield replacement.

Timer Options

Front wiper heaters include the ThermaSync 2812 defroster control. This control provides power modulation and automatic timer shut off. The timer options include 10, 20, 40, 80, 160 minutes and manual off. The timer can be set in the field and eliminates the need for repeated defroster button pushes on long shifts.

The automatic shut off is set to 20 minutes as standard. For different timer options please call in your order.

Installation in cars and light trucks is not recommended

Installing the Clear View Front Wiper Parking Area defrosters is limited to larger vehicles with flatter windshields and adequate room for installation. Many light trucks have steeply sloping windshields and minimum clearance between the glass and dash surfaces which can make installation challenging.

Single Piece Front Windshield Defroster – Wiper Parking Area

1206-4871-L-FWH-HD

Front wiper parking area defroster for single piece windshields. This defroster has six gridlines measuring 5 inches (12.3) in height. Minimum length is 48 inches, maximum 71 which is trimmed to size during installation. Connection tabs are both on the same side for easy wiring. Twenty minute automatic shut off is standard but can be changed. 12 Volts, 50% Modulation. Installation ready. Does NOT include Switch Boss.

1206-4871-L-FWH-HD - $66.20

What’s Included : Single Piece Front Windshield Defroster. Includes ThermaSync 2812 control, switch, wire harness and installation pack. Twenty minute timer, 12 Volts, 50% modulation.

Vertical Side Wiper Push Area Windshield Defrosting

1204-2027-L-SWH-HD

The wiper push area defroster is installed vertically along the edge of the windshield in the wiper push area. Compatible with single and two piece windshields. This defroster has four gridlines measuring 3.5 inches (8.9) in width. Minimum length is 20 inches, maximum 27. Connection tabs are both on the same side for easy wiring. Twenty minute automatic shut off. 12 Volts, 12% modulation. Installation ready. Does NOT include Switch Boss.

1204-2027-L-SWH-HD - $60.45

What’s Included : Vertical Side Wiper Push Area Defroster. Includes ThermaSync 2812 control, switch, wire harness and installation pack. 12 Volts, 12% modulation.

Switch Boss – Operates two defrosters from one switch

2730 Switch Boss

Switch Boss allows single switch operation of two or more Clear View defrosters. Fully configured at the factory and ready to install the Switch Boss can be used to operate both the front wiper parking area defroster (FWH) and the vertical side wiper push area defroster (SWH) from a single switch. Works with 12 and 24 volt systems.

More on Switch Boss single switch operation

2730 Switch Boss Defroster Network - $36.95

Two Piece Front Windshield – Wiper Parking Area

1206-2440-LS-FWH-HD - NEW! Low price and simple installation

Front wiper parking area defroster for two piece windshields. This defroster has six gridlines measuring 5 inches (12.3) in height. Minimum length is 24 inches, maximum 40. Tabs are both on the same side for easy wiring. Both defrosters are controlled from a single switch. Twenty minute automatic shut off. Switch Boss is NOT needed for this defroster. Installation ready. 12 Volts, 50% modulation.

1206-2440-LS-FWH-HD - $97.20

What’s Included : Front Wiper Parking Area Defroster, two piece windshield. Delivered complete ready to install including defroster, 2812 ThermaSync control, switch, wire harness and installation pack. 12 Volts, 50% modulation.

Defroster Accessories

The complete defrosters are delivered ready to install including defroster, 2812 ThermaSync control, switch, wire harness and installation pack. If single switch operation of multiple defrosters is desired then the addition of a Switch Boss is recommended.

ThermaSync Deforster Control

Defroster controls with smarts

Clear View defrosters use 2812 ThermaSync controls which provide several options including operation of multiple defrosters with a single switch plus a range of automatic timing options from ten minutes to continuous operation. ThermaSync 2812/2824 controls are compatible with the Switch Boss which allows several defrosters to operate from a single switch.

More on ThermaSync Defroster Controls

Installation Pack

Delivered ready to install, Clear View Front Wiper Defrosters are complete with ThermaSync defroster control and switch plus an installation pack including wiring harness, under dash mount, fuse and holder, mounting screws, connectors and and other installation accessories plus fully illustrated instructions.

More on Defroster Installation Pack

Defroster installation and wire harness

Switch Boss Defroster Control

Switch Boss

The Switch Boss allows two or more defrosters to be operated from a single switch ideal installing multiple defrosters in a cab. For example the vertical wiper push defroster with the front wiper parking area defroster can be networked together for single switch operation. Up to four defrosters can be networked using Switch Boss. Requires 2812/2824 TheramSync controls.

More on Switch Boss single switch operation